Current position:HOME > News > Industry Dynamic

Wind heating bathmaster installation precautions

Editor:Switch socket _ switch socket to join the agent _ switch socket top ten brands _ Yuba manufacturers wholesale _ Zhejiang GELAN E │ Release Time:2019-01-18 

The bathroom is a relatively humid environment, so there is a particular emphasis on installing the air-heating Yuba. Compared with the design of the wind-heating Yuba, we still need to pay attention to the safety of electricity. Today, GELAN Xiaobian will talk to you about the installation of some precautions.

風暖浴霸安裝注意事項

How to choose the installation position of the air heater?


1. The shower partition is generally one meter eighty-five to one meter high. The general tile is two meters four. The ceiling can be hung on the side of the tile. It is predicted that the partition will be about 30 centimeters away from the ceiling. If the distance between the gusset plate and the partition is too small, in order to improve the efficiency of the air intake, when the wind is warm, the air heater can be turned to the side or the part of the partition can be cut off in the shower. However, the air-conditioning type of air-heating can increase the temperature of the entire bathroom in 3 or 5 minutes after it is fully opened, so the partition has little effect on the wind heating.


2, the wind is not installed in the shower area, or when bathing, there is water on the body, even if it is blowing warm air, it feels very cold. If it is installed above the glass, it is worried that the temperature will affect the glass or have other safety hazards. In fact, you don't have to worry about this problem! Because the air is warmed by the air blower through the heater, causing the room air to convect, so that the room is kept at a constant temperature. If you want to make the thermostatic effect good, you can install a ventilating fan panel above the shower room to increase the air. Circulating flow effect.



What should I pay attention to when installing?


1. Firstly, when bathing, the person standing in the bathroom, the person should face the shower head (the shower head), and the rear upper part of the human back is the position where the wind is warm.


2, the reason why the wind is warmed on the back of the back of the human body, in addition to the heat of the Yuba can stop the heating of the air in the bathroom, it can directly radiate directly to the back of the human body. Because of the bath, the person feels cold is the back. Pay attention to the Yuba not to be placed on the top of the person's head.


3. Keep the bathroom clean and dry. After the bath is finished, do not turn off the wind immediately. Wait until the moisture in the bathroom is drained and then turn it off. Always keep the bathroom ventilated, clean and dry to extend the service life of the wind.



The above is a brief introduction to the installation of wind-heating Yuba, I hope to help you, if you want to know more about the related information, please pay attention to GELAN electrical official website.


CONTACT

Fax:0086-573-83250880 Service Hotline:0086-573-83250886 83250887 Free Service Hotline:400-008-7727 E-mail:gelancn@126.com Address:No. 459, Qingyuan Road, Wangdian Town, Jiaxing City, Zhejiang Province
Follow us

Zhejiang GeLan Electric Co., Ltd.

在線谘詢

聯係電話

400-008-7727

網站地圖凱發K8凱發K8凱發K8凱發K8凱發K8凱發K8凱發K8凱發K8